IFLAG SETUP GUIDE

✔ A quick guide on setting up your ReaperWare iFlag(s).

✔ Follow the below instructions for a quick and easy setup.

IMPORTANT NOTE! Please do not upload a sketch using the Arduino Hardware setup tool to your iFlag. You do not need to do this. Your iFlag is already configured and does not require you to create or upload a sketch. Replacing the already installed sketch will cause the device to stop functioning.

GETTING STARTED WITH YOUR IFLAG

  • SIMHUB IS REQUIRED

    To use your ReaperWare iFlag you must already have SimHub downloaded and installed.

    Although not required, We recommend you purchase a license for SimHub as it's truly an amazing piece of software.

    Download SimHub 

PLUG IN YOUR IFLAG AND CHECK FOR CONNECTIVITY

  • Connect the Device
    Plug your iFlag into any available USB port. You will hear the standard Windows USB connection chime.

    Open SimHub
    Launch SimHub and select the Arduino tab from the left-hand menu panel, then navigate to My Hardware tab at the top of the screen.

    Allow Time to Sync
    Wait a few seconds for detection. Initial synchronization typically takes around 5 seconds, but it can take up to 30 seconds if you are using a new USB port or adding a new device.

  • Verify Status
    The scanning status should change from a red "Not Connected" message to a green "Connected" message, and your device name will appear on screen.

    Troubleshooting Tips

    • Port Compatibility: The device is fully compatible with both USB 2.0 and USB 3.0 ports.
    • Connection Issues: If the status continues to display "Not Connected," wait an additional 30 seconds or try plugging the device into a different USB port.
    • Multiple Arduino Devices: If you have more than one Arduino based device or iFlag's connected, ensure you have Multiple Arduinos selected in the My Hardware tab.

CONFIGURING YOUR SIMHUB LED PROFILE

  • Download the Profiles
    Download the required ReaperWare iFlag profiles.

    Extract the Files
    Navigate to your computer's Downloads folder and extract the contents of the compressed file.

    Navigate to RGB Matrix Settings
    Open SimHub, select the Arduino tab from the left-hand menu, and then click the RGB Matrix tab located at the top of the screen.

    Download iFlag SimHub profiles 

  • Import the Profile
    Click on Profiles Manager, select Import, and choose the specific iFlag LED profile you need. There will be a profile for a single iFlag, and another for a dual iFlag setup.

    Activate the Layout
    Once imported, remember to select and load your new profile from the dropdown menu and apply the changes.

    Your iFlag(s) should activate and show an idle animation when correctly setup.